During the hottest months of the year, your home’s air conditioning system is critical for keeping indoor temperatures comfortable. However, when refrigerant leaks occur, they cannot supply enough cool air, leaving you hot and sweaty and EVEN a hike in energy bills.
It’s essential to know how to check for refrigerant leaks in a home AC system if you don’t want to be left dealing with sweltering conditions during the hot summer months.
The Consequences Of a Leaking HVAC System
Call the air conditioning repair in Battle Ground, WA, if you discover your air conditioner is operating but not cooling. Although pinhole leaks in HVAC systems can occur due to damage, factory faults, or faulty installation, they can become more serious if they are not recognized and treated appropriately.
These leaks must be repaired quickly, not only for your comfort but also because refrigerants hurt the environment and your health. Refrigerants are a hazardous material that, if inhaled, can be lethal, and they harm the environment by destroying the ozone layer.
Sometimes a refrigerant leak could be the cause of your HVAC system’s failure to cool your home this summer. These are the tactics that the air conditioning service near me does when locating the issue.
Three Methods To Detect a Refrigerant Leak in Your HVAC System
1. Dye tests
A dye test is among the most efficient ways to verify a refrigerant leak in your ventilation system—fluorescent dye injects into your HVAC system during this procedure. The substance will flow through every breach that exists after it has had enough time to disperse.
Then, using a detection lamp, scan the HVAC system to find where the dye has escaped. This entire procedure should take no more than a few minutes, although it does necessitate the purchase of specific equipment. You should contact a professional AC repair firm if you don’t have the time, money, or expertise to perform this dye test. This dye test may be done safely and rapidly by them.
2. Soap bubble test
One of the most acceptable methods to attempt if you want to test your HVAC system for leaks without hiring a professional is the soap bubble test. All you have to do is combine soap and warm water. Then, for several minutes, you must mix this solution.
Run it through your AC refrigerant system once you have churned it. Air bubbles will be evident if there are leaks in your system. These places can then be marked so that an HVAC technician knows where patches are needed.
3. Electronic detection
You can use it to look for refrigeration components outside of your home. This electrical device will sound an immediately distinguishable warning when a leak is detected.
The sole drawback is that you can only detect leaks in certain regions where the electronic leak detector comes into contact with refrigerant components. If you’re looking for air conditioning service near me, call us at 360-693-5220.
